ASTM B BM 08 Standard Specification for Copper Alloy Continuous Castings_机械/仪表_工程科技_专业资料。ASTM B BM Chemical Composition according to ASTM B/BM 1Ni value includes Co. Note: Cu + Sum of Named Elements, % min. Single values, unless. ASTM B/BM Standard Specification for Copper Alloy Continuous Castings. standard by ASTM International, 03/01/ View all product details.
|Published (Last):||3 May 2011|
|PDF File Size:||15.30 Mb|
|ePub File Size:||15.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
In such cases the manufacturer shall maintain heat traceability to specific manufacturing date and chemical analysis. C used only in the quench-hardened and tempered TQ30 condition. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM B505 SAE 660 Bronze
Actual practice may vary by manufacturer. Analysis shall be made for residual elements only when speci? ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. If you feel that your comments have not received a fair hearing you should make your views known to the Ast Committee on Standards, at the address shown below.
C silicon brass The cross sections are the diameter of a round solid, the distance across the?
This standard has been approved for use by agencies of the Department of Defense. Sul- Phosfur phorus 0. In such cases the manufacturer shall maintain heat traceability to specific manufacturing zstm and chemical analysis. C high-leaded tin bronze 80 bb505 9.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Each continuous casting from which the test bar was taken shall be identi?
ASTM B / BM – 12 Standard Specification for Copper Alloy Continuous Castings
C leaded semi-red brass 76 2. Test bar specimens shall be positively identi? F Chromium content shall be 0.
From simple blanket orders and multiple releases to asym shelf replenishment delivery and stocking services, our goal is always the same; keep your operation running without inconvenience and your cost of possession at a minimum.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
This leaded tin bronze, alloy C can be produced in 3 ways, continuous cast, centrifugal cast, or sand cast. Combining values from the two systems may result in non-conformance with the standard. If a Brinell hardness is required and a tension b5505 is not required, testing shall be in accordance with Test Method E Marking shall be in such a position as not to injure the usefulness of the casting. Link to Active This link will always route to the current Active version of the standard.
ASTM B / BM – 18 Standard Specification for Copper Alloy Continuous Castings
At the request of the purchaser castings shall be marked with the alloy number. ASTM International astn no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
C leaded nickel bronze Where castings are heat treated, test bar specimens shall be heat treated with the castings they represent. No further reproductions authorized.
C nickel-phosphor bronze Materials and Manufacture 6. C tin bronze Equivalent specifications are verified and updated annually. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Specifications shown are current as of May 4, Each continuous cast bar from which the test qstm was taken shall be identi? A superscript epsilon e indicates an editorial change since the last revision or reapproval. C high-strength yellow brass C leaded nickel-tin bronze